The dumbest stuff just happened. I disabled Droid OC, and tried out the QuickClock Rubix Edition app that came with my Rubix Focused 2.0.1 ROM.but apparently i didnt properly disable Droid OC so it still had my voltage set to high, and the CPU @ 1.35Ghz. But on quickclock, I ran a calibrate test and in the middle of it my phone rebooted and it was like stuck at the moto logo for 20min til I finally pulled the battery, then it went to recovery so i just hit reboot system now and after doing that it finally booted into android, but it took like 15min. Well once i was back to my homescreen everything started lagging like crazy, just to scroll over to the next page on my homescreen it took like 2min. It took forever to open any apps, it was just lagging worse then ive ever seen. So i shutdown the phone and restarted and again it froze at the moto logo so i had to pullbthe battery and do the same thing at the boot recovery screen. Then again once i was at my homescreen eveything was lagging ridiculously bad. Oh and when i tried to unlock my phone, my phone started vibrating for a couple minutes straight and the screen was stuck in one place. So finally after rebooting several times with no change, i had to flash back to my nandroid backup of my Stock ROM. So friggin annoying. Now I'm not 100% sure it was the QuickClock and me overclocking my cpu and the voltage, but that was the last thing i was doing when it happened and i dont see what else could of caused it, cause before that, Rubix was running amazing, i loved, especially after installing the watermark theme. it was nice, but anyways, i aparrently turned my voltage up to high and havin droid OC still enabled so it too was turning my voltage up and my CPU freq set @ 1.35Ghz, and they two messed each other up and in turn messed my phone and rom up, thst is what I'm thinkig happened, and it messed the ROM up. What do you guys think?
Sent from my DROIDX using DroidForums
